Send issues

Common send issues and solutions

Here are the most common send issues you might encounter while using Wraith Wallet, along with suggested solutions.

Insufficient funds

Issue: You may see an “insufficient funds” error when trying to send crypto. This happens when your balance isn’t enough to cover both the amount you want to send and the required network fee (sometimes called gas).

Causes:

Not enough balance in your wallet

Network fees are higher than expected due to congestion

Solution: Make sure your wallet holds enough of the cryptocurrency to cover both the transaction and the fee.

[Learn more about network fees]

Pending transactions

Issue: A pending transaction means it has been broadcast to the blockchain but not yet confirmed.

Causes:

High network congestion

Low gas fees, which makes miners or validators prioritise other transactions

Solution:

Try increasing the fee when submitting the transaction

Check status on a blockchain explorer

Wait until the network clears - sometimes it just takes time

Incorrect recipient address

Issue: Sending to the wrong address is irreversible. Once confirmed, the funds cannot be retrieved.

Causes:

Typing errors when entering an address

Copy - paste mistakes

Malicious software changing the clipboard content

Solution:

Always double-check the recipient address

Use QR codes where possible

If unsure, send a small test amount first

Wrong network selection

Issue: Sending on the wrong blockchain can result in lost or stuck funds. For example, sending ERC-20 tokens to a BEP-20 address.

Causes:

Using an address from a different blockchain

Confusion between wrapped tokens and native ones

Solution:

Always confirm the network before sending

Ensure both sender and recipient are on the same chain

If you made a mistake, contact the exchange or wallet support involved (recovery is not always possible)

Other issues or need more help?

If your problem isn’t listed here or persists after trying these solutions, contact Wraith Wallet Support with:

The transaction ID

Screenshots of the error

A description of what you tried already

[Previous: What to do if I encounter a quote error during a token swap?] [Next: Receive issues]